Parameter list
7.2 Parameter list
Parameter
Function
Determines the control method using the terminals. This parameter allows the selection of the control
philosophy. The control philosophies exclude each other.
2 / 3-wire control allows to start, stop and reverse the inverter in one of the following ways:
2-wire control with Siemens standard control
•
using ON / OFF1 and REV as permanent signals
2-wire control with Siemens standard control
•
using ON / OFF1 and ON_REV / OFF1 as permanent signals
2-wire control
•
using ON_FWD and ON_REV as permanent signals
180
Range
Factory
Can be
default
changed
Scaling
Data
Data
set
type
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Acc.
Level