Siemens SINAMICS V20 Operating Instructions Manual page 244

Parameter list
7.2 Parameter list
Parameter Function
Defines fixed PID setpoint 1. There are 2 types of fixed frequencies:
1. Direct selection (P2216 = 1):
– In this mode of operation 1 Fixed Frequency selector (P2220 to P2223) selects 1 fixed frequency.
– If several inputs are active together, the selected frequencies are summed. E.g.: PID-FF1 + PID-
FF2 + PID-FF3 + PID-FF4.
2. Binary coded selection (P2216 = 2):
– Up to 16 different fixed frequency values can be selected using this method.
Dependency: P2200 = 1 required in user access level 2 to enable setpoint source.
Note: You may mix different types of frequencies; however, remember that they will be summed if selected
together.
P2201 = 100 % corresponds to 4000 hex.
P2202[0...2] Fixed PID setpoint 2 [%]
Defines fixed PID setpoint 2.
Note: See P2201
P2203[0...2] Fixed PID setpoint 3 [%]
Defines fixed PID setpoint 3.
Note: See P2201
P2204[0...2] Fixed PID setpoint 4 [%]
Defines fixed PID setpoint 4.
Note: See P2201
P2205[0...2] Fixed PID setpoint 5 [%]
Defines fixed PID setpoint 5.
Note: See P2201
P2206[0...2] Fixed PID setpoint 6 [%]
Defines fixed PID setpoint 6.
Note: See P2201
P2207[0...2] Fixed PID setpoint 7 [%]
Defines fixed PID setpoint 7.
Note: See P2201
P2208[0...2] Fixed PID setpoint 8 [%]
Defines fixed PID setpoint 8.
Note: See P2201
P2209[0...2] Fixed PID setpoint 9 [%]
Defines fixed PID setpoint 9.
Note: See P2201
244
Range Factory Can be
default changed
-200.00 - 20.00 U, T
200.00
-200.00 - 50.00 U, T
200.00
-200.00 - 100.00 U, T
200.00
-200.00 - 0.00 U, T
200.00
-200.00 - 0.00 U, T
200.00
-200.00 - 0.00 U, T
200.00
-200.00 - 0.00 U, T
200.00
-200.00 - 0.00 U, T
200.00
Scaling Data
set
- DDS
- DDS
- DDS
- DDS
- DDS
- DDS
- DDS
- DDS
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Data Acc.
type Level
Float 2
Float 2
Float 2
Float 2
Float 2
Float 2
Float 2
Float 2