Starting The Motor For Test Run; Quick Commissioning Through The Setup Menu; Structure Of The Setup Menu - Siemens SINAMICS V20 Operating Instructions Manual

Commissioning

5.4 Starting the motor for test run

5.4 Starting the motor for test run
This section describes how to start the motor for a test run to check that the motor speed
and rotation direction are correct.
Note
To run the motor, the inverter must be in the display menu (default display) and power-on
default state with P0700 (selection of command source) = 1.
If you are now in the setup menu (the inverter displays "P0304"), press
seconds to exit the setup menu and enter the display menu.
You can start the motor in HAND or JOG mode.
Starting the motor in HAND mode
1. Press
2. Press
Starting the motor in JOG mode
1. Press
2. Press
5.5 Quick commissioning
5.5.1

Quick commissioning through the setup menu

5.5.1.1

Structure of the setup menu

Functionality of the setup menu
The setup menu guides you through the steps required for quick commissioning of the
inverter system. It consists of the following four sub-menus:
1
2
60
to start the motor.
to stop the motor.
+ to switch from HAND to JOG mode (the
to start the motor. Release
Sub-menu
Motor data
Connection macro selection
. icon flashes).
to stop the motor.
Functionality
Sets nominal motor parameters for quick commissioning
Sets macros required for standard wiring arrangements
Operating Instructions, 09/2014, A5E34559884
for over two
SINAMICS V20 Inverter