Scaling; Can Be Changed; Parameter List - Siemens SINAMICS V20 Operating Instructions Manual

Scaling

Specification of the reference quantity with which the signal value will be converted
automatically.
Reference quantities, corresponding to 100 %, are required for the statement of physical
units as percentages. These reference quantities are entered in P2000 to P2004.
In addition to P2000 to P2004 the following normalizations are used:
● TEMP: 100 °C = 100 %
● PERCENT: 1.0 = 100 %
● 4000H: 4000 hex = 100 %

Can be changed

Inverter state in which the parameter is changeable. Three states are possible:
● Commissioning: C, C(1) or C(30)
● Run: U
● Ready to run: T
This indicates when the parameter can be changed. One, two or all three states may be
specified. If all three states are specified, this means that it is possible to change this
parameter setting in all three inverter states. C shows the parameter is changeable whatever
P0010 equals; C(1) shows that the parameter is changeable only when P0010 = 1; C(30)
shows that the parameter is changeable only when P0010 = 30.
7.2

Parameter list

Parameter Function
r0002 Inverter state
Displays actual inverter state.
0
1
2
3
4
5
6
P0003 User access level
Defines user access level to parameter sets.
0
1
2
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Range Factory
default
- -
Commissioning mode (P0010 ≠ 0)
Inverter ready
Inverter fault active
Inverter starting (visible only while pre-charging DC link)
Inverter running
Stopping (ramping down)
Inverter inhibited
0 - 4 1
User defined parameter list - see P0013 for details on use
Standard: Allows access into most frequently used parameters
Extended: Allows extended access, for example, to inverter I/O functions
Can be Scaling
changed
- -
U, T -
Parameter list
7.2 Parameter list
Data Data Acc.
set type Level
- U16 2
- U16 1
151