Siemens SINAMICS V20 Operating Instructions Manual page 232

Parameter list
7.2 Parameter list
Parameter Function
MODBUS on RS485:
Index: [0]
[1]
...
[7]
Note: Restrictions:
If the above serial interface controls the inverter (P0700 or P0719) then the 1st control word must be
•
transferred in the 1st PZD-word.
If the setpoint source is selected via P1000 or P0719, then the main setpoint must be transferred in the
•
2nd PZD-word.
When P2012 is greater than or equal to 4 the additional control word (2nd control word) must trans-
•
ferred in the 4th PZD-word, if the above serial interface controls the inverter (P0700 or P0719).
P2019[0...7] CI: PZD to USS /
MODBUS on RS485
Displays process data transmitted via USS/MODBUS on RS485.
232
Range Factory Can be
default changed
Received word 0
Received word 1
...
Received word 7
- 52[0] T
Scaling Data Data
set type
4000H - U32 /
I16
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Acc.
Level
3