Siemens SINAMICS V20 Operating Instructions Manual page 259

Parameter Function
[11]
[12]
[13]
[14]
[15]
[16]
Dependency: Set P2800 to 1 to enable function blocks.
All active function blocks will be calculated in every 128 ms, if set to level 1 to 3. Fast free function blocks
(level 4 to 6) will be calculated in every 8 ms.
P2802[0...13] Activate FFBs
Enables free function blocks (FFB) and determines the chronological order of each function block. See
P2801.
0
1
2
3
Index: [0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
Dependency: Set P2800 to 1 to enable function blocks.
All active function blocks, enabled with P2802, will be calculated in every 128 ms.
P2803[0...2] Enable Fast FFBs
Fast free function blocks (FFB) are enabled in two steps:
1. P2803 enables the use of fast free function blocks (P2803 = 1).
2. P2801 enables each fast free function block individually and determines the chronological order
(P2801[x] = 4 to 6).
0
1
Dependency: All active fast function blocks will be calculated in every 8 ms.
Note: Attention: P2200 and P2803 are locked parameter against each other. PID and FFB of the same data set
cannot be active at same time.
P2810[0...1] BI: AND 1
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Range Factory Can be
default changed
Enable NOT 3
Enable D-FF 1
Enable D-FF 2
Enable RS-FF 1
Enable RS-FF 2
Enable RS-FF 3
0 - 3 0 U, T
Not Active
Level 1
Level 2
Level 3
Enable timer 1
Enable timer 2
Enable timer 3
Enable timer 4
Enable ADD 1
Enable ADD 2
Enable SUB 1
Enable SUB 2
Enable MUL 1
Enable MUL 2
Enable DIV 1
Enable DIV 2
Enable CMP 1
Enable CMP 2
0 - 1 0 U, T
Disable
Enable
0 - 0 U, T
4294967295
Parameter list
7.2 Parameter list
Scaling Data Data
set type
- - U16
- CDS U16
- - U32
Acc.
Level
3
3
3
259