Siemens SINAMICS V20 Operating Instructions Manual page 198

Parameter list
7.2 Parameter list
Parameter Function
Defines fixed frequency setpoint 1. There are 2 types of fixed frequencies:
Direct selection (P1016 = 1):
•
– In this mode of operation 1 Fixed Frequency selector (P1020 to P1023) selects 1 fixed frequency.
– If several inputs are active together, the selected frequencies are summed. E.g.: FF1 + FF2 + FF3
+ FF4.
Binary coded selection (P1016 = 2):
•
– Up to 16 different fixed frequency values can be selected using this method.
Dependency: Select fixed frequency operation (using P1000).
Inverter requires ON command to start in the case of direct selection. Therefore r1025 must be connected
to P0840 to start.
Note: Fixed frequencies can be selected using the digital inputs.
P1002[0...2] Fixed frequency 2 [Hz]
Defines fixed frequency setpoint 2.
Note: See P1001
P1003[0...2] Fixed frequency 3 [Hz]
Defines fixed frequency setpoint 3.
Note: See P1001
P1004[0...2] Fixed frequency 4 [Hz]
Defines fixed frequency setpoint 4.
Note: See P1001
P1005[0...2] Fixed frequency 5 [Hz]
Defines fixed frequency setpoint 5.
Note: See P1001
P1006[0...2] Fixed frequency 6 [Hz]
Defines fixed frequency setpoint 6.
Note: See P1001
P1007[0...2] Fixed frequency 7 [Hz]
Defines fixed frequency setpoint 7.
Note: See P1001
P1008[0...2] Fixed frequency 8 [Hz]
Defines fixed frequency setpoint 8.
Note: See P1001
P1009[0...2] Fixed frequency 9 [Hz]
Defines fixed frequency setpoint 9.
Note: See P1001
198
Range Factory Can be
default changed
-599.00 - 15.00 U, T
550.00
-599.00 - 25.00 U, T
550.00
-599.00 - 50.00 U, T
550.00
-599.00 - 0.00 U, T
550.00
-599.00 - 0.00 U, T
550.00
-599.00 - 0.00 U, T
550.00
-599.00 - 0.00 U, T
550.00
-599.00 - 0.00 U, T
550.00
Scaling Data Data
set type
- DDS Float
- DDS Float
- DDS Float
- DDS Float
- DDS Float
- DDS Float
- DDS Float
- DDS Float
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Acc.
Level
2
2
2
2
2
2
2
2