Siemens SINAMICS V20 Operating Instructions Manual page 82

Commissioning
5.6 Function commissioning
● Energy consumption monitoring (r0039, P0040, P0042, P0043)
● Fault and warning reaction setting (r0944 to P0952, P2100 to P2120, r3113, P3981)
● Flying start (Page 116) (P1200 to r1204)
● Free function blocks (FFBs) (Page 115) (P2800 to P2890)
● Frost protection (Page 118) (P3852, P3853)
● Hammer start mode (Page 109) (P3350 to P3354, P3357 to P3360)
● High/low overload (HO/LO) modes (Page 131) (P0205)
A new parameter P0205 is added to enable the HO/LO selection for heavy/low load
applications.
● Imax control (Page 102) (P1340 to P1346)
● Inverter keep-running operation (P0503)
● Inverter status at fault (Page 281) (r0954, r0955, r0956, r0957 and r0958)
This function enables you to read the relevant fault information through parameters
concerned.
● JOG mode operation (Page 86) (P1055 to P1061)
● List of modified parameters (P0004)
A new value is added to parameter P0004 to enable the parameter filter which allows you
to view the modified parameters.
● MODBUS parity/stop bit selection (P2034, P2035)
New parameters P2034 and P2035 are added to enable MODBUS parity/stop bit
selection.
● Motor blocking, load missing, belt failure detection (Page 105) (P2177 to r2198)
● Motor brake controls (Page 91) (holding brake, DC brake, compound brake and dynamic
brake) (P1212 to P1237)
● Motor frequency display scaling (P0511, r0512)
● Motor staging (Page 122) (P2370 to P2380)
● Motorized potentiometer (MOP) mode selection (P1031 to r1050)
● ON/OFF2 function for digital inputs (P0701)
A new value is added to parameter P0701 to run the motor with the ON command or
cancel the inverter pulses with the OFF2 command.
● Parameter cloning (Page 301) (P0802 to P0804, P8458)
● PID controller (Page 89) (P2200 to P2355)
● Pre-configured connection macros and application macros (P0507, P0717) (see also
"Setting connection macros (Page 63)" and "Setting application macros (Page 75)".)
● Programmable V/f coordinates (P1320 to P1333)
● Protection of user-defined parameters (P0011, P0012, P0013)
● Skip frequency and resonance damping (P1091 to P1101, P1338)
● Sleep (hibernation) mode (Page 120) (P2365 to P2367)
● Slip compensation (P1334 to P1338)
82
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884