The typical A-weighted noise level determined according
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
The vibration total value (tri-axial vector sum) determined
according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
manufacturer declare that the following Makita
Designation of Machine:
Slide Compound Saw
Model No./ Type: LS0714, LS0714F, LS0714FL, LS0714L
are of series production and
Conforms to the following European Directives:
And are manufactured in accordance with the following
standards or standardised documents:
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
) : 92 dB(A)
) : 101 dB(A)
) : 2.5 m/s
Anjo, Aichi, 446-8502, JAPAN
General Power Tool Safety
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
Save all warnings and instructions for
ADDITIONAL SAFETY RULES
Wear eye protection.
Keep hands out of path of saw blade. Avoid
contact with any coasting blade. It can still
cause severe injury.
Do not operate saw without guards in place.
Check blade guard for proper closing before
each use. Do not operate saw if blade guard
does not move freely and close instantly.
Never clamp or tie the blade guard into the
Do not perform any operation freehand. The
workpiece must be secured firmly against the turn
base and guide fence with the vise during all
operations. Never use your hand to secure the
Never reach around saw blade.
Turn off tool and wait for saw blade to stop
before moving workpiece or changing settings.
Unplug tool before changing blade or servicing.
Always secure all moving portions before
carrying the tool.
Stopper pin which locks the cutter head down
is for carrying and storage purposes only and
not for any cutting operations.
10. Do not use the tool in the presence of
flammable liquids or gases. The electrical
operation of the tool could create an explosion and
fire when exposed to flammable liquids or gases.
Check the blade carefully for cracks or
damage before operation.
30. 1. 2009