Specifications - Makita LS0714 Instruction Manual

SPECIFICATIONS

Model
Blade diameter
Blade body thickness
Hole (arbor) diameter
Max. Miter angle
Max. Bevel angle
Max. Cutting capacities (H x W) with blade 190 mm in diameter.
Miter angle
0°
45° (left and right)
57° (right)
(Note)
* mark indicates that a wood facing with the following thickness is used.
1: When using a wood facing 20 mm thick.
2: When using a wood facing 15 mm thick.
3: When using a wood facing 10 mm thick.
-1
No load speed (min )
Laser Type (LS0714FL/L)
Dimensions (L x W x H)
Net weight
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
･
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
･
Do not place hand or fingers close to the
blade.
･
Never look into the laser beam. Direct
laser beam may injure your eyes.
45° (left)
* 45 mm x 265 mm Note1
40 mm x 300 mm
* 45 mm x 185 mm Note2
40 mm x 212 mm
-----
END210-6
Bevel angle
0°
* 60 mm x 265 mm Note 1
52 mm x 300 mm
* 60 mm x 185 mm Note 2
52 mm x 212 mm
* 60 mm x 145 mm Note 3
52 mm x 163 mm
Red Laser 650 nm,
LS0714: 13.1 kg, LS0714F: 13.4 kg, LS0714FL: 13.7 kg, LS0714L: 13.5 kg
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
8
LS0714/ LS0714F/ LS0714FL/LS0714L
1.3 mm - 2.0 mm
Left 47° , Right 57°
Left 45°, Right 5°
5° (right)
-----
40 mm x 300 mm
-----
-----
1mW ( Laser Class 2 )
670 mm x 430 mm x 458 mm
equipment
190 mm
20 mm
6,000
and its
ENE006-1
ENF002-2