Output For Machine With Finisher - Konica Minolta bizhub 500 User Manual

Hide thumbs Also See for bizhub 500:

Table of Contents

Finishing/Folding

Output for Machine with Finisher

The machine with Finisher FS-510/FS-511 provides output modes as

described below.

As factory default, Finisher FS-510 is set to output the printed sheets to tray

1 in Group mode.

As factory default, Finisher FS-511 is set to output the printed sheets to

primary tray (tray 2) in Group mode.

- Sort + Offset

- Group + Offset

Downloaded From ManualsPrinter.com Manuals

bizhub 500/420/360 (Phase 3)

Select this setting to separate each set of a multi-page original.

Select this setting to separate the copies of each page in a multi-page

Select this setting to output multiple copies of the original set; each

sorted set will be offset by 30 mm upon exit.

(Secondary tray (tray 1) of Finisher FS-511 is unavailable.)

Select this setting to group together multiple copies of each original and

offsets the sets by 30 mm upon exit.

(Secondary tray (tray 1) of Finisher FS-511 is unavailable.)

Finisher FS-510 is initially equipped with two exit trays, and one optional

output tray OT-601 can be installed. Contact your service representative,

if desired. (Optional output tray is installed in Finisher illustrated above)

Finisher FS-510 is available to output in each tray using every output

Bizhub 420 Bizhub 360