Konica Minolta bizhub 500 User Manual page 701

Utility <Administrator Setting>
4
5
Downloaded From ManualsPrinter.com Manuals
bizhub 500/420/360 (Phase 3)
Adjust the dislocation of fold position on each paper size, referring to a
sample copy made by using Half-Fold mode.
– Touch [2 Half-Fold Position] to display the Half-Fold Position
Screen.
– Select the paper size to be adjusted, then touch [Test Copy].
The Test Copy Screen will be displayed.
– Press [Start] to make a sample copy. When completed, touch
[Close] to return to the Half-Fold Position Screen.
– Compare the page widths of left and right pages to check the
center line of the sample copy. Change the adjustment value if
satisfactory result is not obtained.
Touch [+] to enter the adjustment value if the fold position is off the
center to the right. (Range: 0.5 mm ~ 5.0 mm)
Contrary, touch [–] if it is off to the left. (Range: –0.5 mm ~ –5.0 mm)
– Repeat this procedure until a satisfactory result is obtained.
Adjust the horizontal position of punch holes, referring to a sample
copy made by using Punch mode.
– Touch [3 Punch Horizontal Position] to display the Punch Horizontal
Position Screen.
16
16-79