Konica Minolta bizhub 500 User Manual page 433

Advanced Information
6
7
8
9
Downloaded From ManualsPrinter.com Manuals
bizhub 500/420/360 (Phase 3)
Touch [Job End] on the screen.
The Recall Copy Program Screen will be restored, however, the copy
program selection made in step 3 is released on the screen.
Again touch the desired copy program key to highlight it.
Touch [OK] on the Recall Copy Program Screen.
The job settings of the selected program will be recalled on the
restored Basic Screen.
Press [Start] on the control panel.
The machine will start copying using recalled job settings.
Note
To stop recalling the copy program, press [Reset] or [Mode Memory] on
the control panel. The recalling procedure will be cancelled from any
screen displayed on the touch panel.
Otherwise, touch [Cancel] repeatedly until the Basic Screen is restored.
8
8-17