Konica Minolta bizhub 500 User Manual page 397

Finishing/Folding
7
8
9
Downloaded From ManualsPrinter.com Manuals
bizhub 500/420/360 (Phase 3)
– Touch the desired key to highlight it.
Touch [OK] twice.
The Basic Screen will be restored.
Specify any necessary copy settings.
Press [Start].
The scan/print job will start.
Reminder
Finisher FS-510 trays gradually go up/down while printed materials
output, depending on the tray selected.With Saddle stitcher SD-502 or
Mailbin kit MT-501, the operation of the trays become greater. DO NOT
allow any object to interfere with the operation of the tray around the
finisher, as any interference may cause damage to the finisher.
Finisher FS-511 tray 2 (main tray) gradually goes down while printed
materials output. DO NOT allow any object to interfere with the operation
of the tray 2 (main tray) on the left side of the finisher, as any interference
may cause damage to the finisher.
Note
To cancel changes to the settings, touch [Cancel] on the Finishing
Screen.
To cancel all settings, press [Reset].
If no other setting is desired, the copy job can be started using the
settings currently specified without touching [OK] to return to the Basic
Screen.
7
7-17