Konica Minolta bizhub 500 User Manual page 703

Utility <Administrator Setting>
7
8
Downloaded From ManualsPrinter.com Manuals
bizhub 500/420/360 (Phase 3)
– Press [Start] to make a sample copy. When completed, touch
[Close] to return to the Punch Resist Loop Size Screen.
– Check the hole positions of the sample copy.
Touch [+] or [–] to change the adjustment value if satisfactory result
is not obtained.
Too much adjustment value may cause a fold at the end of paper.
– Repeat this procedure until a satisfactory result is obtained.
Touch [OK] to complete the setting.
– To cancel the change, touch [Cancel].
In either case, the Expert Adjustment Screen will be restored.
If further changes are required, touch the desired key.
16
16-81