Left-Side Components; Removing Left-Side Components - Arctic Cat WILDCAT X Service Manual

Left-Side Components


NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.

NOTE: The engine/transmission does not have to be
removed from the frame for this procedure.
Removing Left-Side
Components
A. Magneto Cover/Stator Coils
B. Water Pump
C. Shifter Assembly
D. Rotor/Flywheel/Starter Clutch
E. Speed Sensor/Trigger Assembly
1. Remove the cap screws securing the magneto cover
to the crankcase; then remove the magneto cover.
Account for the gasket.
GZ212A
AT THIS POINT

To replace stator coils/crankshaft position sensor, see
Electrical System.
2. Remove the starter motor, starter driven gear (A),
starter countershaft bushing (B), and starter counter-
shaft gear (C); then remove the starter gear shafts (D)
noting the longer shaft is nearest the starter.
56
WC917A

NOTE: The starter is not serviceable and must be
replaced as a complete assembly.
3. Remove the rotor/flywheel nut; then install the
appropriate crankshaft protector into the crankshaft.
H2-018
4. Install Magneto Rotor Remover Set and loosen the
rotor/flywheel; then remove the crankshaft protector
and rotor/flywheel from the crankshaft. Account for
the flywheel key.
GZ216
GZ217