DEC Digital Alpha VME 4/224 User Manual page 75

Table 3–2 (Cont.) Environment Variable Summary
Variable
D_EOP
D_GROUP
D_HARDERR
D_OPER
D_PASSES
D_REPORT
D_SOFTERR
D_STARTUP
D_TRACE
DUMP_DEV
ENABLE_AUDIT
EWA0_ARP_TRIES
EWA0_BOOTP_FILE
EWA0_BOOTP_
SERVER
EWA0_BOOTP_TRIES
EWA0_DEF_GINETADDR Specifies the initial value for EWA0_GINETADDR when
EWA0_DEF_INETADDR
EWA0_DEF_INETFILE
Description
Specifies whether end-of-pass messages are to be displayed.
Specifies the diagnostic group to be executed.
Defines the action that is to be taken following a hard error
detection.
Specifies whether an operator is present.
Specifies the diagnostic pass count.
Specifies the level of information to be provided by diagnostic
error reports.
Defines the action that is to be taken following soft error
detection.
Specifies whether a diagnostic startup message is to be
displayed.
Specifies whether trace messages are to be displayed.
Specifies that a device is to write operating system crash
dumps.
Specifies whether audit trail messages are to be generated
during bootstrap.
Specifies the number of transmissions to be attempted before
the Internet Address Resolution Protocol (ARP) fails.
Specifies a generic file name to be included in an Internet Boot
Protocol (BOOTP) request.
Specifies a server name to be included in a BOOTP request.
Specifies the number of transmissions that are to be
attempted before BOOTP fails.
the interface's internal Internet database is initialized from
BOOTP (EWA0_INET_INIT is set to BOOTP).
Specifies the initial value for EWA0_INETADDR when the
interface's internal Internet database is initialized from
BOOTP (EWA0_INET_INIT is set to BOOTP).
Specifies the initial value for EWA0_INETFILE when the
interface's internal Internet database is initialized from
BOOTP (EWA0_INET_INIT is set to BOOTP).
Operating the Digital Alpha VME 4 Computer 3–5
(continued on next page)