Show_Log - DEC Digital Alpha VME 4/224 User Manual

Table of Contents

Advertisement

show_log

show_log — display NVRAM error log information
Displays console-detected fault information that was previously stored in the
error log area of NVRAM.
If you do not specify command-line options, the command displays the most recent
fault.
Console error logging is completely independent of the operating system's error
logging.
Syntax
"
#
-n [count]
show_log
-all
-new
Options
-n count
Displays the number of most-recent faults indicated by count that are logged into
the NVRAM error log area. The default value for count is 1.
-all
Displays all faults logged into the NVRAM error log area. All faults are marked
as seen so that new faults can be easily displayed using the -new option. This
command always displays all logged faults.
-new
Displays all new faults logged into the NVRAM error log area; displays all faults
that have not been previously displayed by the show_log -all command.
Examples
>>> show_log
1.
=============================== F A U L T #1 ================================
Time of Error: 13:08:39 9-AUG-1994
Diagnostic
: Interval Timer
Pass Count
: 1
Error Message: Interrupt not invoked and should have been
>>>
By default, the most-recent fault is displayed.
13–96 Console Commands
Test Number: 4
Failing Point: 18

Advertisement

Table of Contents
loading

This manual is also suitable for:

Digital alpha vme 4/288

Table of Contents