Table of Contents
Advertisement
update
-target device
Specifies the device that contains the FEPROMs to be upgraded. Valid targets
are CONSOLE and USERFLASH.
Examples
1.
>>> update -fi alphavme_v1_1-0 -dev ewa0 -prot
mop -tar console
update -path mop:alphavme_v1_1-0/ewa0 -target console
.....
Network load complete.
Host name: OHMY
Host address: aa-00-04-00-00-4b
new: 1.1-0
Note: Module DIP Switch #2 must be CLOSED to enable Updates!
EXECUTING THIS PROGRAM WILL CHANGE YOUR CURRENT ROM!
Do you really want to continue [Y/N] ? : Y
DO NOT ATTEMPT TO INTERRUPT PROGRAM EXECUTION!
DOING SO MAY RESULT IN LOSS OF OPERABLE STATE.
The program will take at most several minutes.
Erasing the target flash device...
........
Erasure completed.
Programming...
........
Programming completed.
Verifying...
Update successful
>>>
The example above shows how to do an update using the MOP protocol.
2.
>>> update -fi //usr//local//bootfiles//alphavme_v1_1-0 -dev ewa0 -tar
console -pro tftp
update -path tftp://usr//local//bootfiles//alphavme_v1_1-0/ewa0 -target
console
EXECUTING THIS PROGRAM WILL CHANGE YOUR CURRENT ROM!
Do you really want to continue [Y/N] ? : y
DO NOT ATTEMPT TO INTERRUPT PROGRAM EXECUTION!
DOING SO MAY RESULT IN LOSS OF OPERABLE STATE.
13–104 Console Commands
FEPROM UPDATE UTILITY
-----> CAUTION <-----
FEPROM UPDATE UTILITY
-----> CAUTION <-----
Advertisement
Table of Contents
Troubleshooting
