Replacing A Lens - Christie Roadie HD+35K User Manual

Section 4: Maintenance
5. Remove the air filter as follows:
Using your fingers, pull out top of filter to remove, as shown.
Replace/Install New Air Filter
1. To replace or install a new filter, place the top of the air filter inside the air filter compartment and slide all
the way up behind the tabs, then push the bottom of the air filter in.
2. With the filter in place, insert the bottom tabs of the filter door into the corresponding slots, close the filter
door, and secure again with the 2 screws.
4.5

Replacing a Lens

A variety of lenses can accommodate different throw distances and specific types of installations. Refer to the
Christie website for throw distance calculations.
To replace or change a lens:
1. Unclip the lens safety tether from the handles or FredFrame .
2. Release the lens-locking lever (UP position).
4-10
Only use Christie filters. Never operate the projector without the filter installed.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)