Turning The Lamp On/Off - Christie Roadie HD+35K User Manual

Lamp Ballast (7kW)

3.10.3 Turning the Lamp ON/OFF

NOTE: Refer to
Lamp ON
1. With the projection head and ballast connected to each other, and the breaker/power switch ON, press
M
ENU
. The LCD Status Display at the rear of the projector shows a "Lamp Size" of 2000, 3000, 4500 or
6000 watts, depending on its last setting. Factory default=6000. Use L
the lamp that is currently installed. This should also appear on the Lamp Installed label located on the
lamp door.
NOTE:
A lamp password is required to change lamp type/size, unless the "Enable Password" service option has
been turned OFF. Refer to
2. Turn the projection head and lamp ON by pressing the POWER key on either the projector's built-in
keypad or standard IR remote.
3. For subsequent power-ups of this lamp, press the POWER key. There is no need to reset the lamp size until
a different-sized lamp is installed.
NOTE:
Refer to
Lamp OFF
1. Press the POWER key on either the projector's built-in keypad or standard IR remote.
2. WAIT for fans to continue running for 10 minutes to cool the lamp.
3. Proceed with full shutdown of the system, if desired.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Lamp
Lamp Hours
Lamp S/N
1. Lamp Message
2. Lamp Limit
3. Lamp Mode
Power
4.
5. Intensity
6. Reserved
7. Lamp History
8. Change Lamp
*
Cable Length (m)
9.
0. LampLOC
Metric / Imperial Conversion
6 ½ ft. = 2 m
25 ft. = 7.5 m
50 ft. = 15 m
100 ft. = 30 m
*
Figure 3-35 Define Lamp Cable Length
Section 3.2.6 Keypad and Standard IR Remote Functions
Figure 3-33
Section 3.2.6 Keypad and Standard IR Remote Functions
0
1234
1000
Power
3545
1246
15
#ft.
= #meters
3.28
Up to 100 ft. Cables
.
Section 3: Operation
for more information.
A or R A
EFT RROW IGHT RROW
for more information.
to select
3-59