Safety Warnings And Guidelines; General Precautions; Ac / Power Precautions - Christie Roadie HD+35K User Manual

4 Maintenance
Installers, service trained operators and all other users must maintain a safe operating environment at all times.
Read through this section in its entirety and understand all warnings and precautions before attempting to
operate the projector.
4.1

Safety Warnings and Guidelines

This projector is designed for safe and reliable operation. However safe operation is not assured by design
alone; installers, service technicians, trained operators and all other users must maintain a safe environment at
all times.
IMPORTANT!

4.1.1 General Precautions

NOTES: 1)
The American Conference of Governmental Industrial Hygienists (ACGIH) recommends occupational
UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters of effective UV
radiation. An evaluation of your workplace is advised to assure employees are not exposed to cumulative
radiation levels exceeding the government guidelines for your area.
are known to increase sensitivity to UV radiation.
This projector must be operated in an environment that meets the operating range specification, as listed in
Section 6 Specifications.
This projector must be installed in an environment that meets the operating range specifications in
Specifications.

4.1.2 AC / Power Precautions

Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Please read through and understand all warnings and precautions before attempting
to operate the projector.
Never look directly into the projector lens or at the lamp. The extremely high
brightness can cause permanent eye damage. For protection from ultraviolet
radiation, keep all projector housings intact during operation. Protective safety
clothing and safety goggles are recommended when servicing. Keep hands, clothes
and all combustible material away from the concentrated light beam of the lamp.
Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
Fire Hazard. Keep hands, clothes, and all combustible material at least 1m away from the
:
concentrated light beam of the lamp.
: Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
: Opening or removing a projector cover requires a qualified service technician.
Do not attempt operation if the AC supply is not within the specified voltage
range.
Shock Hazard. Disconnect projection head and ballast from AC before opening any
enclosure.
2)
Be aware that some medications
Section 6
4-1