Projector Basics; Air Filter - Christie Roadie HD+35K User Manual

3 Operation
This section describes how to use the controls and switches for basic projector operation once it is properly
installed, aligned and configured by a Christie accredited service technician, as described in
Installation and
3.1

Projector Basics

Primary Roadie HD+35K components are identified below:
ON
OFF
Air
Filter
Handles
(1 piece)
3-Phase 7 kW Ballast
Projector components are briefly described and listed in alphabetical order in the following section.

3.1.1 Air Filter

Intake air flows through the filter before circulating in the front compartment to cool the main electronics.
Replace the air filter whenever the lamp is replaced-or sooner in dusty/dirty environments. Refer to
Replacing the Lamp & Filter
IMPORTANT! Check condition monthly.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Setup.
Refer to Safety Warning and Guidlines in
Wired IR
Remote
Lamp
Leveling Feet (4)
Rear
Connection
Panel
ON/OFF Breaker
3-Phase
Status LEDs
& Voltmeter Line Cord
Figure 3-1 Basic Roadie HD+35K Projector and Related Components
for complete instructions.
Section 4 Maintenance
Projection Head
Exhaust Hood
(incl. extractor fan )
Status &
Control
Panel
Rear IR
Sensor
Line
Inputs
Cord
Communications
Interlocks
Control
Section 2
.
Front IR Sensor
Anode
Lead
Cathode
Lead
Section 4.4
3-1