Hoisting And Stacking - Christie Roadie HD+35K User Manual

Special Orientations
Since this projector cannot be inverted or tilted beyond 15°, all installations are typically front-mount or rear-
mount and require the "Front" or "Rear" Image Orientation setting in the

2.3.5 Hoisting and Stacking

For most installations, you will likely have to safely lift or hoist this projector-or a stack of two projectors-into
place. Keep in mind the following critical safety guidelines for all handling of the projector.
Carrying/Moving the Projection Head
Four or more people can lift and hand-carry one projection head a short distance using the handles or the
optional FredFrame™ , if installed. NEVER carry a stack of projectors.
Hoisting/Rigging a Single Projection Head
A single projection head can be hoisted and/or suspended using its handles, a set of rigging clamps (#113-
102101-xx), and appropriate rigging and safety cables. If desired, the lamp ballast can also be flown from its
integral rigging bars. To hoist, stack or "fly" a stack of projectors you must use the optional
Refer to Using the FredFrame™
Read the following safety warning before hoisting/ rigging ONE projection head. Refer to 020-100133-
XX for more information.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Figure 2-19 Side to Side Tilt
described below.
Any overhead suspension used MUST be suitably rated for the weight of the
projector. The projector's weight is 435 lb / 197.3 kg.
Maximum load rating of the projector's handles is 435 lb / 197.3 kg.
Use straps and/or cabling with load capacity adequate for the total projector and
handles when lifting/hoist. Never exceed the load rating specified.
Use the projector's handles for hoisting/rigging ONE projector only. Never try to
carry more than one projector.
Remove the projection lens before hoisting/rigging.
Max.
±15°
Section 2: Installation and Setup
Configuration
menu.
FredFrame™ .
2-17