Christie Roadie HD+35K User Manual page 21

c. Use the U
indicated on the lamp door label.
Once the Status Display shows the correct lamp type, the projector and lamp can be switched ON.
NOTE:
Lamp size can also be changed in the
running, but it will not take effect until the next power-up. Whenever possible, define the lamp size before
igniting the lamp .
6. Switch the projector and lamp ON. Using either the built-in keypad or the standard IR remote, do one of
the following to switch the projector ON, and ignite the lamp:
• press and hold P
• press P
OWER
the projector)
• press P
OWER
The main PROJ. STATUS light at the rear of the projector should be green when the projector is up-and-
running. For best results, let the projector warm up for about 5 minutes.
7. Select the source. Using either the IR remote or built-in keypad, press the appropriate Input key (1-6) to
display the image for the corresponding source connected as described in Step 3. The display will resize as
needed, producing an image as large as possible for the type of source present.
8. Adjust the Image. Adjust the more common image settings, such as Brightness, Contract, Gamma, etc.
using the keys directly on the standard IR remote.
You can also access the Menu system and adjust these and other image settings by pressing M
standard IR remote.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
HOW TO SET THE LAMP SIZE:
Or standard Christie service password.
Figure 2-5 Setting Lamp Size
/D A
P OWN RROWS to select which lamp is currently installed. Make sure the lamp type is also
OWER
for at least two seconds
and then press the U
P
twice quickly to toggle from the projector's present ON/OFF state
1.
Enter Lamp Password:
2.
1
3.
Lamp Size
6000
Select installed lamp size:
2000
3000
4500
6000
Service
menu (Service password required) if the projector is
or D
OWN
Arrow key (useful if you are unsure of the present state of
Section 2: Installation and Setup
Press "Menu" before power up.
Screen below displays lamp size.
on built-in
keypad
or
on the
4 7 0
standard
IR remote
on built-in
keypad
or
on the
standard
IR remote
ENU
on the
2-5