Christie Roadie HD+35K User Manual page 113

DMX Channel
Base + 6
Base + 7
Base + 8
Base + 9
* Functions are only active when the
† Lens functions have no effect on the Roadie HD+35K.
NOTE:
It is important to make sure the channels DO NOT overlap another device.
Example:
Device Name. This option is used to name each device. Some ArtNet servers support querying for devices.
Device Description. More information that is returned when a "device query" has been done.
Broadcast Key
Select the check box if you want remote/keypad commands sent to one projector to be relayed to all projectors
in a serial network. Note that the P
you to control a specific projector when necessary. Make sure to clear the Broadcast Key check box when
operating redundant networks.
Backlight
Toggle the built-in keypad lighting ON/OFF.
Front IR / Back IR
As described in Section 2, the standard IR remote is capable of sending data to the projector in either one of
seven different protocols called A - G, depending on its internal jumper settings (default= A ). Likewise, the
front and rear IR sensors on the projector can be set to accept IR data accordingly, responding to one of the A -
G protocols, all or none. The projector's "Always" default is adequate for most single-projector installations.
Select a specific protocol to work with only certain projectors in a multi-projector group.
Note that the front and rear IR sensors cannot respond to different protocols-changing a protocol for either
sensor to anything other than OFF changes the protocol for the other sensor too. For example, setting Front IR
to E also changes the Back IR to E . If you want only one sensor to respond to a particular protocol, you must
disable the other sensor by setting its protocol to OFF.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Function
Lens – Focus * † 0
1 – 254
255
Lens – Zoom * † 0
1 – 254
255
Power * 0
1 – 254
255
None
Slider Lock
Proj1_Base = 0
Proj2_Base = 10
Proj3_Base = 20
ROJ
key temporarily "overrides" the effect of a broadcast setting and allow
Value
Negative Focus
Stop
Positive Focus
Zoom Out
Stop
Zoom In
Power Off
No Action
Power On
is set to Unlocked.
Good Bad
Proj1_Base = 5
Proj2_Base = 9
Proj3_Base = 11
Section 3: Operation
3-47