2: Installation And Setup; Projector Quick Setup And Installation; Quick Setup - Christie Roadie HD+35K User Manual

2 Installation and Setup
This section explains how to install, connect and optimize the projector for delivery of superior image quality.
Illustrations are graphical representations only and are provided to enhance the understanding of the written
material.
2.1

Projector Quick Setup and Installation

Follow these steps for quick setup of the projector in a basic front-mount position. Refer to the remaining
subsections for detailed setup instructions.

2.1.1 Quick Setup

1. Position the Projection Head.
Locate the projection head at an appropriate throw distance (projector-to-screen distance) and vertical
position. Refer to
Distance calculations. Refer to
and is not inverted. The projector's front-to-back and side-to-side tilt can be no more than 15 degrees from
horizontal. Position the lamp ballast so that its four cables can reach the rear of the projection head.
2. Install the Lamp and Lens.
Refer to Section 2.4 Installing Lens, Lamp, and Cooling
3. Connect a Source.
Connect your desired source to the appropriate connector(s) on the main Input panel, located on the side of
the projector (lens side) as shown in
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Always power down the projector and disconnect all power sources before servicing
or cleaning.
Refer to
Section 4.1 Safety Warnings and Guidelines
Section 2.3 Projector Position and Mounting
Section 6.2
Figure
Figure 2-1 Connect to Input Panel
and the Christie website for Throw
Lenses. Make sure that the projector is level from side-to-side,
for installation instructions.
2-1.
.
2-1