Christie Roadie HD+35K Instruction Sheet

Roadie HD+35K Portrait Upgrade Kit

SAFETY AND WARNING GUIDELINES

INTRODUCTION

The Roadie HD+35K projector must be installed in a Christie rigging
frame (P/N 38-814007-XX) and suspended as not to block
ventilation. The projector can be used in portrait mode after installing
the upgrade kit. The following instructions detail the steps required
to install the portrait upgrade kit.
Roadie HD+35K Portrait Upgrade Kit Instruction Sheet
020-100778-03 Rev. 1 (03-2012)
HIGH VOLTAGES MAY BE EXPOSED! Always power down and
disconnect power sources prior to servicing. Once the projector is
powered down, allow the cooling fans to automatically turn OFF before
disconnecting from AC and opening the projector.
QUALIFIED SERVICE
replacement procedures must be performed by Christie accredited
service technicians.
NON-INSULATED DANGEROUS VOLTAGES MAY BE EXPOSED! Always
disconnect from AC prior to disassembly.
OBSERVE ALL ELECTROSTATIC PRECAUTIONS! Use a grounded wrist
strap when handling electronic assemblies.
Never operate the projector (or the fans) without all the covers installed.
Failure to operate the projector in the correct portrait mode orientation
can cause severe damage to the projector.
Instruction Sheet
TECHNICIANS REQUIRED! All module
1 of 4