Time-Outs; The Global Icon; The Pip Icon; Using Slidebars And Other Controls - Christie Roadie HD+35K User Manual

Section 3: Operation

3.5.2 Time-outs

If a slidebar, menu, or message is present, you have limited time in which to make an entry on the built-in
keypad and standard IR remote before the projector returns to its Presentation level, and the H
disappears. These time-outs may vary depending on what is displaying.

3.5.3 The Global Icon

Menu
options that include this icon apply universally to any incoming signal.

3.5.4 The PIP Icon

Menu options that include this icon apply to PIP (secondary) images only.

3.5.5 Using Slidebars and Other Controls

Most of the Function menus allow you to change settings by using slidebars, check boxes, and drop-down lists.
To select a slidebar, select or clear a check box, or view a drop-down list, do one of the following within a
Function menu:
• Enter the current menu option number corresponding to the setting you wish to change (for example, press
1+3 to select the Vertical Stretch option in the Size & Position menu).
• Move U or D
P
• Or move the highlight to the option desired, and press the R
• Or bypass the menus entirely, and use a single key to immediately access an adjustment during your
presentation (applies only to options which have their own key on the standard IR remote, such as C
B ness, G
RIGHT
• For "blind" access, hide the entire
direct slidebarslidebars activated by their own key (such as C
proper keypress or numerical sequence of key presses.
Once selected, change the setting as desired (see below). Changes take effect immediately and are saved upon
exit from all menus, or after 15 minutes.
Slidebars in Menus
The current value for a given parameter, such as size or vertical stretch, appears to the left of its slidebar icon
(Adjustment window). This number often expresses a percentage, or it may have units associated with it (such
as pixels, degrees Kelvin, etc.), depending on the specific option. Press the R
gradually adjust the setting up or down-both the number and the length of the bar change accordingly. Hold for
continuous adjustment. Or press E
in keypad or standard IR remote, then press E
"Direct" Slidebars
For quick access, you can access Gamma, Brightness, and Contrast slidebars without traveling through the
Menu system. For example, simply press C
Contrast
with the
Use the Arrow keys to adjust a direct slidebar, or press E
keypad or standard IR remote, then press E
When you are done, press E
3-18
to highlight the desired option, and press E
OWN
AMMA
, etc.).
Menu
NTER to activate a slidebar text box for a specific number entry via the built-
Image Settings
option in the
XIT
to save and return to your presentation.
NTER
IGHT
system (refer to OSD (On-Screen Display)
trast, B
ON
to save (or press E
NTER
to immediately display the same C
ONT
menu.
NTER
and type a specific number from the built-in
or the R or L
NTER IGHT EFT
to select.
and L
EFT
Arrow keys to adjust immediately.
Key, above) and/or
RIGHT ness, etc.). Control by using the
or L
IGHT EFT
Arrow keys to
XIT
to cancel).
ONTRAST
Arrow keys to save (or E
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
ELP
graphic
ON
trast,
slidebar accessed
XIT
to cancel).