Christie Roadie HD+35K User Manual page 76

Section 3: Operation
You must have an unlocked channel present to use A
NOTE:
Help Function Key
Press the H
ELP
key (either the built-in keypad and standard IR remote) to display summary information about
the current menu or highlighted menu option. Or, if there is no menu present, press H
general Help topics. To exit any Help text display, press the H
Channel Selection Key
Press the C
HAN
memory. Once you enter a 2-digit channel number (or, if there is a list available, highlight the Channel option,
and press ENTER) , the display automatically changes and updates according to the numerous setup parameters
defined for the selected channel. Understand that a new channel is automatically created if you adjust an image
from a new source.
The C
HAN
NOTE:
option is enabled in the
when you press the C
on-screen feedback. Refer to
Input 1 Key (BNC)
Press the I
NPUT
enabled, press INPUT 1 to assign it as the PIP source. This option is not available with some models.
Input 2 Key (DVI)
Press the I
NPUT
enabled, press INPUT 2 to assign it as the PIP source.
Input 3 Key (VID)
Press the I
NPUT
press INPUT 3 to assign it as the PIP source. This option is not available with some models.
Input 4 Key (S-VID)
Press the I
NPUT
INPUT 4 to assign it as the PIP source. This option is not available with some models.
3-10
Table 3.3 Auto Setup
OPTIMIZES:
Size and Blanking
Vertical Stretch
Position
Input Levels
key to select a specific source setup (channel) already defined and stored in the projector's
key behavior during a presentation depends on whether or not the Display Channel List
Menu Preferences
HAN
key, or you may prefer to enter the desired Channel number "blind", i.e., without
Menu Preferences
1 key to display from the data input source connected to BNCs labeled INPUT 1. If PIP is
2 key to display from the DVI source (analog or digital) connected to INPUT 2. If PIP is
3 key to display from the composite video source connected to INPUT 3. If PIP is enabled,
4 key to display from the S-video source connected to INPUT 4. If PIP is enabled, press
What an "Auto Setup" Does
SETS TO DEFAULT:
Auto Input Level (off)
Detail (if video source)
Filter
Luma Delay
S
UTO ETUP
ELP
menu. You can choose to use a scrollable list of channels
later in this section.
.
ELP
to access a list of
key again or press EXIT .
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)