Lamp Cable Lengths - Christie Roadie HD+35K User Manual

Hide thumbs Also See for Roadie HD+35K:
Table of Contents

Advertisement

Section 3: Operation
NOTES: 1)
Setting the lamp size requires a
Christie accredited service technician.
The required password for access is a
service option that may be turned off.
Current lamp size should also be
recorded on the "Lamp Installed" label
located on the lamp door-see right.
Mark the appropriate lamp size using a
small blue dot label (see inside cover of
this manual), or mark with a dry-erase
pen.
If the projector is already running, consult the
projector's memory. If this does not match the installed lamp, you can either change the Lamp Size setting in
the service password-protected
power down and press M
Figure
3-34. Always indicate current lamp size on the

3.10.2 Lamp Cable Lengths

The high-voltage DC cables connected between the lamp ballast and the rear of the projection head can be 2-30
meters in length, depending on your site requirements and setup. The length currently in use must be defined in
projector software for any new installation. This setting compensates for the voltage drop that occurs over
distance and ensures that the proper voltage is maintained at the lamp. In the
Length (m)" slidebar to match that of your DC cables. By default from the manufacturer, this setting is 8
(approximately 25 feet). See
3-58
HOW TO SET THE LAMP SIZE:
Or standard Christie service password.
Figure 3-33 Checking/Setting Lamp Size
Service
ENU
to use the LCD for lamp selection, as described above (passwords are shown in
Figure
3-35.
1.
Enter Lamp Password:
2.
1
3.
Lamp Size
6000
Select installed lamp size:
2000
3000
4500
6000
2)
Figure 3-34 Use the "Lamp Installed Label
Status
menu to see which lamp size is currently recorded in
menu, which implements the new size at the next power-up, or you can
Lamp Installed
Press "Menu" before power up.
Screen below displays lamp size.
on built-in
keypad
or
on the
4
7
0
standard
IR remote
on built-in
keypad
or
on the
standard
IR remote
label.
Lamp
menu, set the "Cable
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)

Advertisement

Table of Contents
loading

Table of Contents