Anamorphic Lens; Error Conditions - Christie Roadie HD+35K User Manual

Section 3: Operation

3.14.1 Anamorphic Lens

NOTES: 1)
The anamorphic lens and its mounting structure are optional components.
the anamorphic lens, refer to the instructions included with the anamorphic lens mount kit.
anamorphic lens mount is required for use of the 1.26x anamorphic lens, producing 2.39:1 "scope"
images. However, the lens mount cover must be removed when installating the anamorphic lens mount and
in order to the use the MALM.
An optional anamorphic lens (1.26x) can be installed into an optional motorized auxiliary lens mount, and then
swung into place to widen a "squeezed" image into a properly proportioned "scope" display (2.39:1). This lens
increases magnification across the width only; retaining the original proportions of the image, and is often used
with screens where side-masking can be moved aside or in rooms having fixed side masking , but a very short
throw ratio (throw distance/screen width).

3.15 Error Conditions

Occasionally the projector will encounter an error condition that can interrupt normal operation. Such a
condition can be caused by a simple invalid entry, an input signal error (most common) or a system error. The
manner in which users are to be notified of error conditions is set in the
• To see error messages displayed on-screen, select the
• To be notified via a serial communication only, select the
• To receive both types of notifications, select
• To disable error messages (except for "invalid user key entry", which can't be hidden), select
NOTE:
Text-based status/error messages also appear in the LCD Status Display window above the built-in keypad
at the rear of the projector. They are accompanied by their corresponding 2-digit error code next to the
built-in keypad, legible at a greater distance. Normal operation is indicated by the "0N"status code.
User Errors
Invalid User Entry
A entry not recognized by the projector triggers a short on-screen error message identifying the problem. For
example, if you specify a channel number that is not available, the message "Invalid Channel will appear. Or if
you try to enter the wrong password, you'll see "Invalid Password". Press E
and try again.
NOTE:
On-screen display of "Invalid User Entry" messages cannot be disabled, even if Display Error Messages
has been set to "OFF".
Input Signal Errors
An input signal error message occurs if you are in presentation level (i.e., there are no menus present) and have
selected an input on which the projector detects a problem. While menus remain operational and any key press
will temporarily remove any displayed error message, you must resolve the signal problem in order to
permanently eliminate the message.
No Signal
The message "No signal" occurs when there is no source signal detected at the selected input-both HSYNC and
VSYNC are inactive, and the screen background is black. Connect or correct the signal, or try another input.
3-78
Screen
option
RS232
option.
All
.
2)
To install, replace or use
3)
Menu Preferences
menu:
OFF
or E
NTER XIT to clear the message
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
The optional
.