Ir Remote Protocols And Adjustment - Christie Roadie HD+35K User Manual

2.14 IR Remote Protocols and Adjustment

At manufacture, every remote is assigned "A" as its default protocol, which is simply a collection of settings
that determine how the remote operates. Once assigned, this protocol remains in effect until you change its
protocol. The standard IR remote can operate using one of 7 different protocols, or it can be set to a "wired"
protocol when a cable is added for connecting the remote to the projector. Changing a remote's protocol is done
via "hard-wired" jumper settings inside the remote.
The IR remote protocols A-G are generally used for multiple-projector applications. For example, you might
want to change a remote's protocol if you need to control multiple projectors independently (see
When Remote A operates under a different protocol than Remote B (or others), each remote communicates
only with the projector(s) having a matching protocol defined in memory.
NOTE :
Matching the protocol on the projector to that of a remote is done through a setting in the Communications
secondary menu. Refer to
information on how to define which protocol the projector's infrared sensors (rear and front) will
recognize.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Figure 2-52 Proper Fold Mirror Adjustment
Section 3.8 Adjusting System Parameters and Advanced Controls
Figure 2-53 Independent Remotes and Projectors
Section 2: Installation and Setup
Figure 2-53).
for further
2-47