Converting A Remote - Christie Roadie HD+35K User Manual

Shortcut Method
Unlike earlier Christie projectors and remotes, there is no shortcut method for changing a remote's protocol
through a special sequence of keystrokes. You must change the internal jumper settings.

2.14.2Converting a Remote

If desired, you can convert an IR remote into a wired remote and vice versa. Set the jumpers as shown in
Figure 2-55, and add or delete the cable and batteries as required. The cable with appropriate connector is
supplied with the projection head.
To Change from Infrared to Wired:
1. Remove battery compartment cover from back of remote.
2. Remove batteries.
3. Wait 1-2 minutes.
4. Plug the remote cable (supplied) into the empty battery compartment. Pack with foam as an internal strain
relief. Make sure that the battery cover is notched smoothly to accommodate the cable without pinching it.
5. Set the remote's protocol to "wired" jumper setting (refer back to
between pins 2 and 3 as shown in the last example (shaded).
6. Replace battery compartment cover.
7. Plug into the 3-pin XLR port at the rear panel of the projector.
To Change from Wired to Infrared:
1. Unplug the remote's cable from the projector.
2. Open the remote back and unplug the remote cable.
3. Wait 1-2 minutes.
4. Install batteries. Refer to
5. Set jumpers according to the desired IR protocol (refer back to
between pins 1 and 2, as shown for all remote protocols.
6. Replace battery compartment cover.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 2.14.1 Standard IR Remote
Section 2: Installation and Setup
Figure 2-55). Make sure to set jumper #4
Protocols.
Figure 2-55). Make sure to set jumper #4
2-49