Copying A Channel - Christie Roadie HD+35K User Manual

Signal Types
Either Channel list, whether the C
shortened form as defined below. These description codes indicate what signal information the projector uses
to identify a match for a given channel, and are preceded by either an "i" (interlaced signals) or "p"
(progressive signal"). Refer to
Table 3.5 Abbreviations for Signal Type
Codes
4WH Composite (4 wire) on HC input
4WV Composite (4 wire) on V input
SG Sync-on-green
5W Separate H,V
5WR Separate H,V swapped
SVid S-Vid
CVid Composite Video
Dig Digital
Functions within the Channel Setup Menu
To copy, delete or edit a channel, highlight the desired channel in the
things:
• Press F
UNC
if you want to copy the selected channel or delete one or more channels. See

Copying a Channel

• Press E
NTER
if you want to edit a channel's setup (i.e., non-image related parameters) for the selected
channel. Refer to
3.7.5 Copying a Channel
Making a copy of a channel is a quick way to duplicate a channel that contains most of the settings you need
without creating a new one from scratch. This then allows you to adjust the settings specific to the new
presentation required.
To make a Copy of an existing channel, highlight the desired channel in the
F
UNC
to open the
channel. It is identified with the next available channel number (01-99). The new channel is identical to the
original channel, but it is identified with the next available number from 01-99. If you change your mind and
do not want to copy the current channel, press E
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
HAN
key list or the
Figure 3-21.
Signal Type
or refer to Section 3.7.6 Deleting One or More
Section 3.7.7 Editing a Channel
Channel Copy/Delete
Channel Setup
Setup.
secondary menu. Select "
XIT
to cancel and return to the previous menu.
Section 3: Operation
menu, identifies signal types in a
Channel Setup
menu and do one of two
Channels.
Channel Setup
" and press E
Copy NTER
Section 3.7.5
menu, and press
to create a new
3-39