System Configuration (Geometry & Color) - Christie Roadie HD+35K User Manual

Section 3: Operation
To disable both IR sensors, you cannot use the IR remote to select the second OFF setting. This safeguard
prevents accidentally disabling a remote while you are using it. Instead, use either the built-in keypad or the
wired remote (optional) to set the remaining active sensor to OFF. The projector no longer responds to an IR
remote.
NOTE:
The standard IR remote for this projector is set at manufacture to "Protocol A". Refer to
Remote Protocols and Adjustment
supporting software.
Wired Keypad
Select "On" to enable use of a wired remote connected to either the rear of the projector (standard IR remote
with XLR connector) or the side input panel (optional Lite remote with phono-jack connector). The projector
will then respond to incoming commands from either port. To disable the wired remote, you must use a
different either the built-in keypad or another IR remote to select "OFF". This safeguard prevents you from
accidentally disabling the wired remote during use.
3.8.3 System Configuration (Geometry & Color)
Configuration
In the
overall color performance and/or image geometry for all sources.
Test Pattern
Choose the desired internal test pattern, or select OFF to turn a test pattern OFF. Alternatively, use the T
key for cycling through test patterns.
Keystone
NOTE:
If the optional Christie TWIST module is installed, this option is Keystone and Warping, and activates a
secondary menu for defining custom image shapes. Please refer to documentation included with your
Christie TWIST module.
3-48
for information about changing the remote protocol for use with
Geometry and Color
menu, select the
9.
secondary menu when you need to modify
Reserved
Reserved
Section 2.14 IR
EST
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)