Standard Ir Remotes - Christie Roadie HD+35K User Manual

2.6.1 Standard IR Remotes

As desired, direct the projector's standard IR remote towards the display screen or the projector's IR sensors.
Alternatively, connect a wired version of the remote to either the three-pin XLR connector rear (standard) or
the 3.5mm phono jack on the side of the projector, depending on which type of cable you are using with this
remote.
NOTE:
Response to a wired remote must also be enabled in the Communications menu. Refer to
Adjusting System Parameters and Advanced Controls
NOTE:
If both wired remotes are connected, communications via the side Input panel has priority over
communications via the rear.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Standard IR
Remote with
XLR Connector
Figure 2-32 Remote Options
Section 2: Installation and Setup
for more information.
Optional
"Lite" Remote
3.5mm Phono
Jack Connector
Section 3.8
2-29