Christie Roadie HD+35K User Manual page 122

Section 3: Operation
Use the first of six (1-6) options in the
PIP.
Options 7 and 8 pertain to source switching only, and are not supported in this projector.
Swap Main and PIP Image
Short Cut: Press S
Toggle the current picture-in-picture relationship so that the primary (main) image becomes secondary (PIP),
and the secondary image becomes primary. Swapping is available only when PIP is enabled (option 1).
NOTE:
There may be a slight delay when swapping the Primary and Secondary images.
PIP Enable
Short Cut: Press PIP from your presentation.
Toggle to display from two sources at once
(Picture-in-Picture) or the primary source only.
This check box turns the secondary source ON
and OFF.
NOTE:
Disable PIP for Interlaced sources >
35kHz.
PIP Size and Position Secondary Menu
PIP Size and Position
Controls in the
manner as the main controls in the
descriptions. Additional options unique to the PIP image are described below.
Position Presets
Set the location of the PIP (secondary) image in the display.
Aspect Ratio Presets
Set the desired aspect ratio of your PIP image to "Default" or "Anamorphic". Refer back to
Image Settings Menu
Advanced Size and Position
Refer back to Advanced Size and Position Secondary Menu
3-56
PIP and Switching
1.
Swap Main and PIP Image
2.
Picture
3. PIP Size & Position
-in-
4. PIP Image Settings
Picture
Options
5.
PIP Border Width
6.
PIP Border Color
7.
Image Optimization
8.
9.
Numbers Select Main Image
Figure 3-32 PIP Menu
SWITCHING is not applicable for the projector
(
PIP and Switching
WAP
from your presentation.
menu affect the PIP (secondary) image, functioning in the same
Size and Position
for details.
PIP Enable
4
Red
Fade Time
PIP Only
menu to enable and define how you want to use
menu. Refer to Section 3.6.3 Image Settings Menu
for details.
Switching
Options
(n/a)
)
Section 3.6.3
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
for