Ballast Breaker/Power Switch (On/Off); Control Panel (Rear Of Projector) - Christie Roadie HD+35K User Manual

Section 3: Operation

3.1.2 Ballast Breaker/Power Switch (ON/OFF)

The breaker/power switch located on the lamp ballast serves two purposes:
1) It is a power switch for the Roadie HD+35K ballast.
2) It protects against over-current conditions of 50A or more.
The breaker/power switch must be in the ON position to enable normal Roadie HD+35K system power-up and
operation. If faulty or major excessive AC is detected, the breaker/power switch "trips" to OFF in order to
prevent damage. Try switching the breaker/power switch ON again. If the breaker/power switch continues to
trip OFF, this indicates a major fault, and the AC problem must be resolved. Possible causes might include
shorts, damage to lamp cables, or very excessive AC.
You must press POWER on the built-in keypad as the breaker/power switch does not power up the
NOTE:
projector or start the lamp.
The ballast's internal fan is the only indication whether or not the breaker/power switch is ON. Lights on the
ballast indicate only that the ballast is plugged in.

3.1.3 Control Panel (Rear of Projector)

The rear control panel includes the built-in keypad, IR sensor, 2-digit status/error code display window, and the
LCD status display, as described in
Table 3.1 Rear Projector Control Panel
Control Panel Area
Built-In Keypad
IR Sensor
Two-Digit Status/Error
Code Window
LCD Status Display
3-2
Table 3.1.
LCD Status Display Window
On/Off
Status/Error Code Display
Figure 3-2 Rear Control Panel
Provides access to all software controls needed for working with the projector. For
more convenient functionality, you can use a remote, web browser, or a serial message-
based method of control.
Sensors at the front and rear of the projector detect commands from the standard IR
remote.
The code that displays in this window indicates the basic operational state of the
projector. Each code references its corresponding status/error message and displays it
in the LCD Status Display window. Refer to
list of all possible codes and corresponding messages.
Full status and error messages appear in this window.
Status info and error
messages appear here
Auto
Input 1
Menu
Setup
BNC
Lens
Input 3
Focus Zoom Help
Shift
Video
Input 5
Shutter Exit
Opt.1
Description
3.15.1 System Warnings/Errors
IR Sensor
Input 2
DVI
Input 4
S-Vid
Input 6
Opt. 2
Built-in Keypad
for the
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)