Control; Wired Remote (Converted From Ir Remote); Ir Remote; Ethernet - Christie Roadie HD+35K User Manual

Section 6: Specifications

6.4 Control

6.4.1 Wired Remote (Converted from IR Remote)

2 inputs on projection head
Input levels
Voltage output
Current output
Cable length

6.4.2 IR Remote

Number of IR sensors on projector
Wavelength of peak sensitivity
Modulation (carrier) frequency
Encoding method
Range
(using optional "lite" remote)
Assumes no fluorescent lighting interference.
If range appears limited, shield the IR sensor, turn off lights, or change your fluorescent ballast.

6.4.3 Ethernet

Number of ports
Standard
Connector type
Max. baud rate
6.4.4 RS-232 Serial Input
Number of connectors
Connector type
Max. baud rate
6.4.5 RS-422 Serial Input
Number of connectors
Connector type (side input panel)
Connector type (rear connector panel)
Max. baud rate
6-4
• 3-pin XLR connector (rear)
• 3.5mm phono jack (side)
• High = 2.2 V – 5.6 V (or open)
• Low = -0.6V – 0.9V @ 1mA
+5VDC ±5%
100 mA nominal, 250 mA max.
25 ft.
2 (front and rear)
1000 nm (approx.)
38 kHz (nominal)
bi-phase
100 ft.
50 ft. min.
1
100Base-TX
RJ-45
115200
2
9-pin subminiature D (female=in,
male=out)
115200
2
1 x 9-pin subminiature D
1 x 6-pin XLR
115200
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)