Controlling Your Pip Image - Christie Roadie HD+35K User Manual

For best PIP or Seamless Switching results, use two different signal types* as defined below. Do not mix two
signals of the same type.
Signal Type
#1
#2
#3
#4
#5
#6
*
HD interlaced sources are not recommended for the PIP window.
Other PIP or Seamless Switching tips to keep in mind include:
• When using 2 digital signals or 1 analog and 1digital, each must be 165 MHz or less.
• When using two analog signals, each must be 90 MHz or less.
• Avoid using an interlaced source in the PIP window
• Seamless switching may affect image quality in some cases
• Seamless switching is not currently supported in this projector

3.9.1 Controlling Your PIP Image

NOTE:
Controls for the primary image are all accessed through the Main menu. To control the secondary (PIP)
image, access picture controls through the PIP and Switching menu.
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Figure 3-31 Blanking of a PIP Image
Description (Input Location)
5 BNCs (RGBHV or YPbPr)
DVI - I (analog or digital)
Decoded signals (Input 3, Input 4, Composite video, S-Video, or any video
signal via Input 1 BNC connectors or via an analog option card).
Analog Option Cards
Digital Option Cards
Digital Option Cards
Section 3: Operation
3-55