Yamaha 2006 RX10GTAXW Service Manual page 910

PRIMARY SHEAVE AND DRIVE V-BELT
4-7
ASSEMBLY
1. Install:
S Sliding sheave
(onto the spider)
NOTE:
Be sure the sliding sheave match mark (X) is
aligned with the spider match mark (X).
2. Install:
S Fixed sheave
(onto the spider)
NOTE:
S Clean the threads.
S Apply LOCTITE648 to the fixed sheave as
shown.
CAUTION:

LOCTITE should be applied only to the
specified area. Never apply it to the bush-
ings and other areas.
a 16 mm (0.63 in)
b 30 mm (1.18 in)
3. Install:
S Fixed sheave stoppers 1
NOTE:
Stopper tapered portion should face fixed
sheave.
4. Tighten:
S Spider
Tightening steps:
S Finger-tighten the spider until it is stopped by
the fixed sheave stopper.
S Hold the fixed sheave with the clutch spider
separator 1 .
Clutch spider separator:
90890-01711, YS-28890-B
NOTE:
Securely fit the projections on the clutch sepa-
rator adapter 2 into the fixed sheave holes.
POWR
TR