Yamaha 2006 RX10GTAXW Service Manual page 1066

A.C. MAGNETO AND STARTER CLUTCH
3. Remove:
S Starter clutch
NOTE:
S While holding the magneto rotor with the
sheave holder, remove the starter clutch bolt
1 .
S Do not allow the sheave holder to touch the
projection on the magneto rotor.
Sheave holder
90890-01701, YS-01880
4. Inspect:
S Starter clutch rollers 1
Damage/wear ! Replace.
5. Inspect:
S Starter clutch idle gear 1
S Starter clutch gear 2
Burns/chips/roughness/wear ! Replace
the defective part(s).
S Starter clutch gear's contacting surfaces a
Damage/pitting/wear ! Replace the starter
clutch gear.
6. Inspection:
S Starter clutch operation
Installation steps:
S Install the starter clutch gear 1 onto the start-
er clutch 2 and hold the starter clutch.
S When turning the starter clutch gear clockwise
A , the starter clutch and the starter clutch
gear should engage, otherwise the starter
clutch is faulty and must be replaced.
S When turning the starter clutch gear counter-
clockwise B , it should turn freely, otherwise
the starter clutch is faulty and must be re-
placed.
5-34
ENG