Yamaha 2006 RX10GTAXW Service Manual page 1116

CRANKCASE
5. Lubricate:
S Piston
S Piston rings
S Cylinder
S Crankshaft pins
S Big end bearings
(with the recommended lubricant)
Recommended lubricant
Engine oil
6. Offset:
S Piston ring end gaps
a Top ring
b Lower oil ring rail
c Upper oil ring rail
d 2nd ring
e Oil ring expander
7. Install:
S Big end bearings
S Connecting rod assembly
(into the cylinder and onto the crankshaft
pin).
S Connecting rod cap
(onto the connecting rod)
NOTE:
S Align the projections on the big end bearings
with the notches in the connecting rods and
connecting rod caps.
S Be sure to reinstall each big end bearing in its
original place.
S While compressing the piston rings with one
hand, install the connecting rod assembly into
the cylinder with the other hand.
S Make sure that the "Y" marks a on the con-
necting rods face towards the right side of the
crankshaft.
S Make sure that the characters b on both the
connecting rod and connecting rod cap are
aligned.
5-59
ENG