Yamaha 2006 RX10GTAXW Service Manual page 880

STEERING
CAUTION:
Always use new cotter pins.
Locknut (rod end):
25 Nm (2.5 mSkg, 18 ftSlb)
LOCTITE
Nut (tie rod-idler arm):
30 Nm (3.0 mSkg, 22 ftSlb)
Nut (tie rod-steering arm):
35 Nm (3.5 mSkg, 25 ftSlb)
5. Install:
S Steering shaft 1
S Locknuts 2
S Joints 3
Steering
A
Shaft part
number
227.8 mm
8FA-23840-00
(8.9685 in)
NOTE:
Make sure that the end of the steering shaft with
the indentation a is connected to the steering
clumn.
CAUTION:
Always use new cotter pins.
Nut (steering shaft):
35 Nm (3.5 mSkg, 25 ftSlb)
3-9
CHAS

Set
B C Shaft
a b
length length
170.0 mm
(6.6929 in)