ELECTRICAL STARTING SYSTEM
5. Measure:
S Brush length a
6. Measure:
S Brush spring pressure
Assembly
Reverse the "Disassembly"procedure.
Note the following points.
1. Before installing the front bracket and rear
2. Make sure the front bracket and rear bracket
3. When installing the rear bracket assembly,
4. Install:
S Securing bolts (starter motor)
8-15
Out of specification ! Replace the starter
motor.
Brush wear limit:
5 mm (0.20 in)
Fatigue/out of specification ! Replace as a
set.
Brush spring pressure:
7.36 X 11.04 N
(736 X 1,104 g, 26.0 X 38.9 oz)
bracket, apply bearing grease to the bear-
ings of the front bracket and rear bracket.
cover are fitted with O-rings.
take care not to scratch the brushes.
ELEC