Yamaha 2006 RX10GTAXW Service Manual page 702

SPECIAL TOOLS
FOR ENGINE SERVICE
S Piston pin puller
P/N: YU-01304 (for U.S.A./Canada)
90890-01304 (for Europe)
This tool is used to remove the piston pin.
S Rotor holding puller, attachment
P/N: YU-33270 (for U.S.A./Canada)
90890-01362 (for Europe)
P/N: YM-33282
90890-04089
This tool is used to remove the magneto rotor.
S Cooling system tester, adapter
P/N: YU-24460-01 (for U.S.A./Canada)
90890-01325 (for Europe)
P/N: YU-33984 (for U.S.A./Canada)
90890-01352 (for Europe)
This tester is used for checking the cooling system.
S Oil filter wrench
P/N: YU-38411 (for U.S.A./Canada)
90890-01426 (for Europe)
This tool is needed to loosen or tighten the oil filter cartridge.
S Carburetor synchronizer
P/N: YU-8030 (for U.S.A./Canada)
90890-03094 (for Europe)
This guide is used to synchronize the carburetors.
S Compression gauge set
P/N: YU-33223 (compression gage) (for U.S.A./Canada)
90890-03081 (for Europe)
P/N: YU-33223-3 (adapter) (for U.S.A./Canada) (for Europe)
90890-04136 (for Europe)
These tools are used to measure engine compression.
S Valve spring compressor set, quick release, attachment
P/N: YM-04019 (valve spring compresser) (for U.S.A./Canada)
90890-04019 (for Europe)
P/N: YM-4108, YM-4114 (attachment) (for U.S.A./Canada)
90890-04108, 90890-04114 (for Europe)
These tools are used-to remove or install the valve assemblies.
S 40 and 50 mm bearing driver.
Water pump seal installer.
P/N: YM-4058 (40 and 50 mm bearing driver) (for U.S.A./Canada)
90890-04058 (for Europe)
P/N: YM-33221 (water pump seal installer) (for U.S.A./Canada)
90890-04078 (for Europe)
These tools are used to install the water pump seal.
1-5
GEN
INFO