Table of Contents
Advertisement
DRIVE V-BELT/ENGAGEMENT SPEED CHECK
4. Inspect:
S Drive V-belt
Cracks/damage/wear ! Replace.
Oil or grease on the V-belt ! Check the pri-
mary and secondary sheaves.
5. Inspect:
S Primary sheave
S Secondary sheave
Oil or grease on the primary and secondary
sheaves ! Use a rag soaked in lacquer thin-
ner or solvent to remove the oil or grease.
Check the primary and secondary sheaves.
6. Measure:
S Drive V-belt circumference a
Out of specification ! Replace.
V-belt circumference:
1,129 X 1,137 mm
(44.4 X 44.8 in)
ENGAGEMENT SPEED CHECK
1. Place the machine on a level surface of hard-
packed snow.
2. Inspect:
S Clutch engagement speed
Inspection steps:
S Start the engine, and open the throttle lever
gradually.
S Check the engine speed when the machine
starts moving forward.
Out of specification ! Adjust the primary
sheave.
Engagement speed:
3,600 ± 200 r/min
(RX10, RX10S, RX10R, RX10RS)
4,200 ± 200 r/min
(RX10M, RX10MS)
2-29
INSP
ADJ
Advertisement
Table of Contents
Troubleshooting
