Yamaha 2006 RX10GTAXW Service Manual page 1008

ENGINE ASSEMBLY
INSPECTION
1. Inspect:
S Engine mounting adjust bolts
Cracks/damage ! Replace.
INSTALLATION
NOTE:
After installing all parts, refer to "CABLE ROUT-
ING" in CHAPTER 9, to check the cable, lead
and hose routing.
1. Install:
S Engine mounting adjust bolts
S Engine
S Engine mounting bolts and nuts
NOTE:
S Use the pivot shaft wrench to tighten the en-
gine mounting adjust bolts.
Installation steps:
S Tighten the rear engine mounting adjust bolt.
Bolt (engine mounting adjust):
7 Nm (0.7 mSkg, 5.1 ftSlb)
S Tighten the rear engine mounting nut.
Nut (engine mounting):
65 Nm (6.5 mSkg, 47 ftSlb)
S Tighten the front right and left engine mount-
ing adjust bolts until they come to cantact
with the engine damper. At this time, do not
apply torque to the engine mounting adjust
bolts.
S Tighten the front right and left engine mount-
ing nuts.
Nut (engine mounting):
65 Nm (6.5 mSkg, 47 ftSlb)
2. Fill:
S Coolant
Refer to "COOLING SYSTEM" in CHAPTER
2.
3. Fill:
S Engine oil
Refer to "ENGINE OIL REPLACEMENT" in
CHAPTER 2.
5-5
ENG