Table of Contents
Advertisement
A
B
C
STEERING SYSTEM/LUBRICATION
3. Adjust:
Adjustment steps:
S Loosen the locknuts (tie-rod) 1 .
S Turn the tie rods 2 in or out until the specified
S Tighten the locknuts (tie-rod) 1 .
After tightening the inside and outside ball
joint locknuts 1 , make sure the tie rod 2
can be rotated freely through the ball joint
travel. If not, loosen the locknut 1 and re-
position the ball joint so that the tie rod 2
can be rotated freely. Tighten the locknuts to
specification.
A Left side
B Right side
C Inside
LUBRICATION
Brake lever, throttle lever and throttle cable
end
1. Lubricate the brake lever pivot, throttle lever
Apply a dab of grease onto only the end of
the cables.
Do not grease the throttle cables.
They could freeze and cause a loss of con-
trol.
2-41
S Ski toe-out
toe-out is obtained.
Locknut (rod end):
25 Nm (2.5 mSkg, 18 ftSlb)
LOCTITE
CAUTION:
and the ends of the throttle cables.
Recommended lubricant:
ESSO Beacon 325 Grease
WARNING
INSP
ADJ
Advertisement
Table of Contents
Troubleshooting
